Here are the other shots you requested. I tried many angles, lights, etc., yet could not get an accurate picture of the natural light setting. The silicone carbide is so reflective that it goes to light grey in all of the shots, and the smoke glass looks pale green/blue where in reality it looks almost black.
Another description that may be even more appropriate of the daytime look is that of a neatly piled burned out fire, except that all of the “ash” is reflective and sparkly.
Can not explain why in some of the shots the flame appears greenish. The blue colored flames are not exactly right either. The real color is closer to ultraviolet than anything else.
Several of the shots, including 01, 29, and 50, have been taken from the same location. You can tell the ones taken at full open valve by the increased amount of color in the shots.
Additional photos in separate mailings
I am very happy with my “new” gas fireplace. I thought I would share with you the enclosed photos taken with an ordinary digital camera with no ambient light except the fire itself. The camera was placed in various locations around the fire on the hearth proper. Unfortunately the stills cannot depict the fire action. What is amazing about the fire is the low spread out blue flame pattern instead of the conventional tall yellow flames in the middle.
The fireplace is open on three sides 30”x40”, The pit was filled with coarse bagged lava rock form Home Depot approximately 1” deep to the bottom of the U shaped burner gas pipe with the holes pointing down. It was then topped with Moderustic fine lava rock to fill in the voids on the top leaving the bottom of the burner only slightly submerged below the layer of the finer lava rock from Moderustic..
The next layer was black sand followed by S----- C-----. The sand was mounded in the center over the burners. A sprinkling of grey glass over the SC and a topper of Bronze ½” glass was sprinkled over the smaller sized matrix to finish. The final product is very dark and reflective with tiny reflections off of the s----- c------ and larger reflections off of the gradated glass during the day and in ambient light. It looks a little like a lava field that you might run across in the Mojave Desert near Barstow. Not at all showy, yet very subtle to the view in daylight.
The coarse lava rock on the bottom layer, with the finer layer on top to keep the gas in longer, acts as manifold carrying gas to all portion of the firebox floor covered with that material. I stopped the coarse rock short of the metal posts in a semi circular shape in plan and back filled with sand so that the flame would not reach the posts. The visual result around the posts is that the gas reaching the end of the coarse material immediately goes upward creating a flowing arc of fire around the posts. This is seen as a blur in the photos.
The underlying coarse rock distributes the gas pretty evenly across the firebox floor creating a even matrix of small flames on the surface as it works its way up through the media. The extreme perimeter appears more active. There are more constant more steady flames from the mound. Because there is less gas at the perimeter, the gas there burns in horizontal spurts and appears like lightning bolts licking the edges of the firebox.
There are small vortexes of fire that form and sometimes work there way around the base of the mound on the center but usually preferring a particular area to hang out.
The overall effect is one of a dispersed flame. As if the entire bed of the fireplace is afire with a low blue flame. With all the lights out in the room it is quite magical. Not at all anything like a conventional yellow flame in the center. Due to the dispersion of the flame across the large firebox area, there is a lot of heat generated and dispersed into the room instead of up the flue. This is not a design for summer time nights.
Everyone who witnesses this flame is impressed with the “light show” quality of the burn.
In the future I plan to change out the media and experiment with different ways to direct the gas and resultant flame to achieve different effects.
Next time I am thinking of laying a pattern of coarse rock and infilling between the “arms” of coarse rock with sand so that the gas will follow the “arms” and come up in more predictable places, perhaps creating little vortexes or pyres at the ends of the “arms”.
The pictures below are of a log converted fireplace in Newport Beach now we can even produce tornadoes! This fireplace has Starfire Base Glass, Diamonds and a few cool fire tornadoes! We can control the size and duration of these little fire devils!
This is our latest venture and the first ones will be installed in a month or so. We will be posting pictures of the completed project. These are very futuristic Tiki Torches if that's what you would like to call them, enjoy.
This last one looks like Wilma Flintstone?
What we have done is create a vortex and added fire! These will be made available in all sizes, colors and shapes. Stay tuned for more installation pictures!
The Sticks below are a pro-to type of 2 sets that are being installed in Nipomo California in the Trilogy project by Shea Homes (Pismo Beach). We will follow up with completed pictures as soon as we have time to post the finished project. There are several fireplaces which will also be all electronic ignition as well
At the base of each burner there is a control valve to regulate the flow of fuel to the burner. The base will be covered with our black sand to conceal the valves. We will post pictures of the finished and completed project.
The fireplace below is in Hope Ranch, Santa Barbara, California. First we installed the double "H" burner.
Then we pour 2" of crushed lava rock as a base over the burners.
Here you can see the lightly coated Black Magic with our glass for accents and sparkle.
Here you can see the Diamonds. When you see the Diamonds in the fire they appear to be melting but actually they are only reflecting inside which looks like they are melting. They are made from crystal. And with everything just right you have the Black Magic look!
The next several pictures are of a 24" x 54" x 3 1/2" deep triangle pan with our first Ribbon Burner! It lays in a bed of black silicone carbide "Black Magic"
The flames measured 24" tall below! Because of the design we implied to this new burner they seem to be coming from nowhere!
We didn't fill the pan with sand just because. These ribbon burners will be available very soon and we will post dozens more pictures as we have time to post them for you to see. The will be available in steel or stainless steel. With or with out a pan. This burner was built for another customer in Palm Springs for their fireplace and we will post pictures of it as well.
This pan will be installed in a custom table built by the customer in Palm Springs.
The fireplace below is a Malm Carousel Fireplace. We replaced the attempted dual burner which it was originally installed with with a simple 12" steel ring.
This fireplace has a safety pilot light kit which was still left intact for local code reasons but we did get rid of the non functioning pan burners.
Below we poured the crushed lava base up to and just covering the ring burner.
• Returns must be made within 30 days of purchase with exceptions only by management. • Returned products must be unused and/ or unmixed. • Returned products must be packaged well to avoid damage in transit, OR YOU WILL BE RESPONSIBLE FOR THE DAMAGE. • Returned products that are damaged in transit will not be able to be refunded. • Refunds will be made towards product cost only. • Refunds will not be given for non-product labor costs (consulting fees, installation fees, labor, shipping etc.) • Restock fees may apply depending on which items are being returned. (30% to 70%)
Glass/ burning products 30%, Burners 50%, Custom Burners 70%, Metal Pans or any Custom Metal Work, Electronics are not returnable ever!
• Refunds are processed after customer’s review and acceptance of refunded amount. • Refunds take approximately 1 week for processing less any customer delays. • Any return must have a return authorization in writing by the management and this will be noted. • There are no returns or refunds on any custom metal products what so ever! • We are not responsible for local codes and or if any of our products are or are not approved. Please check with your local building department or governing agencies for proper approvals before purchasing. Custom built or designed items are not returnable for any reason. • Any Designs, Drawings, PDF Files, Ideas, Pictures, Attachments, Renderings, Facsimiles, Faxes, Blue Prints, Copies, Documents and even copy written materials once sent to Moderustic Inc, Ed Jaunzemis, Aquatic Glassel or any employee of Moderustic Inc becomes property of said company to use, distribute, copy, reproduce, manipulate, recreate, modify, advertise, promote, lay claim to and or use in our discretion as we need. If you do not agree with these terms then please do not send us anything. Our intentions are to create for you the "Customer" and it is our vast collection of material that will spawn an idea for you to have us create something for you. If we should create something/ anything for you that is one of a kind, you do not own any rights to this or there idea or ideas, product or concept in any way shape or form. • EXPEDITED SHIPPING NOTICE (i.e. 2/ 3-Day Select, Next Day/ 2nd Air, etc.): If UPS/ FedEx fails to deliver your packages within the expedited delivery time frame you have chosen, they can or will refund a PORTION of the delivery charges. We will pass 100% of the UPS/ FedEx refund back to you. The amount refunded is determined by UPS/ FedEx and will be less than the original expedited shipping charge that you originally paid. This is due to surcharges and fuel charges. We do not determine what will be credited back. Click Here to see additional Terms and Conditions!
* All orders charged in full are to be deemed Custom. All custom orders are charged 100% in full. All of the pictures and content are copy written on this website: U.S. Copyright Registration No is: VA 1-650-624 Entitled: "Moderustic 1107" Effective registration date is February 1, 2008. Has anyone ever told you "Nice Logs" ? Nooo, I don't think so. CSLB# C-17 693887 - US patent # 7,976,360 B2 - Violators will be prosecuted.
We are exploring the possibility of sharing this opportunity with the right individuals. We firmly believe that in the right hands our innovative products may present immense opportunity. This is not a cookie cutter franchise package, nor a percentage sale of our company. Rather this is a product(s) specific investment that begins with a conversation and arrives at a mutually beneficial partnership. Read More
"Click" on the two links below for multiple videos on Moderustic site Currently under-development, our latest product "tubED" is a fire feature that uses sound waves to electronically excite gas molecules. Check out the Video Here.
Fireplace Burners 150 different types of burners Single, double, triple, H pattern, Double H pattern, Triple H pattern to name a few. Check it out!
Metal Fire Rings Rounds,with and without centers, singles, doubles, triples, quads and quints (5) half rounds,star burners, u burners, h burners and on and on. And if this is not enough we will custom build a burner to your specifications. Any and or all of these burners can and will be calibrated to burn propane or natural gas. Check it Out!
Propane Pans In brushed aluminum, stainless steel, brass, copper, steel or any other metal finish you would desire!Check it Out
Fireplace FireBalls Available in painted or Glazed and Hallow. Color options include RED, LIGHT BROWN, DARK BROWN, SILVER, BLACK, WHITE, DARK GRAY, LIGHT GRAY, TERRACOTTA. Check it Out!
Fireplace Clay Stones and Concrete Shapes and Balls. Available in various sizes and colors. Check it Out!
Logos in FireGlass Available in any size or design! Choose your colors from our large selection of FireGlass and we build custom frames that match your logo. Put this in your fireplace or fire pit Check it Out!
Custom Fireplace Surround Frames Our surrounds can be made from Aluminum or Stainless Steel, or whatever material you like. There are often small imperfections, but that's because they are hand made; not machine manufactured.Check it Out!
Vortex Fires For both indoor and outdoor. With optional remote control, propane conversion, vinyl or marine vinyl covers, and pedestals. Size and cost range from:
18" x 18" by 36" high, with windshield. Clear glass = $1200 Reflective = $1600
18 x 18 by 48" high, with windshield. Clear glass = $1200 Reflective = $1600 Without Windshields 12" x 12" by 36"high Clear glass = $800 Reflective = $1200
12" x 12" by 48" high Clear glass = $800 Reflective = $1200
Portable FireGlass Fire Pits Available in both propane and natural gas. These are made from perforated aluminum or whatever material you'd like. We can customize these to suit any size, shape or material, even with wheels. Check it Out!
Black Magic, Blue Flames Our black magic sand will give your fire pit or fireplace that WOW factor you always wanted. Check it Out!
Custom Fire Bowls No job is too big or too small. We can provide the right type of custom burners and FireGlass to fulfill the toughest commercial job expectations. Check it Out!
FireGlass for Custom Fireplaces We've helped thousands of people with their custom fireplaces. From homes in Beverly Hills to boutique Hotels. There's no project we fear. Check it Out!
Fire Tables with FireGlass Want beauty & function together? Custom fire tables provide warmth and elegance. Commercial or residential, no problem. Check it Out!
Indoor Fires We've worked on some amazing indoor fire tables over the years. Propane or Natural gas jobs. Check it Out!
Outdoor Fire Pits Our FireGlass can make any fire pit look better! Check it Out!
Custom Water and Fire Features We fear no custom jobs. From propane or natural gas flames, water features combined with fiber optic color lights. Just ask, chances are we can make your dreams come true! Check it Out!